Canon PIXMA G3260
setup is not completing.
Canon PIXMA G3260 setup is not completing? Printer setup fails most often when the app, network band, or device discovery step does not match what the printer expects. For this Canon PIXMA G3260, pay special attention to Canon PRINT discovery, GI-21 ink flow, and rear-tray paper alignment.
Try these in order.
Stop as soon as the printer behaves. Each step removes one likely cause without changing settings you may need later.
- 01
Start from a clean device list
Remove failed duplicate entries from the official app and operating system before starting setup again. On the Canon PIXMA G3260, use Canon PRINT or the printer control panel for this check.
- 02
Pair beside the router
Keep the printer and phone or computer close to the main router, and use the primary 2.4 GHz network during the first setup.
- 03
Restart the setup sequence
Restart the printer, router, and app in that order. Wait for the router to finish booting before opening the setup utility.
Usually one of these.
- Canon PRINT discovery, GI-21 ink flow, and rear-tray paper alignment is the model-specific checkpoint to verify first.
- The setup app is using a different account, network, or device than the printer.
- The router is hiding the 2.4 GHz network or isolating new devices.
Move to the deeper fix.
Reset only the network settings
Use the model guide to reset network settings, not the full factory state, then add the printer again from the official setup app.
Finish by IP address
If discovery fails but the printer has an address, add it manually with the official TCP/IP or network-printer option. Use the official Canon support page for the exact Canon PIXMA G3260 package before changing firmware or resetting the device.
Before you reset everything.
Why does printer setup stop at the last step?
The printer may have joined Wi-Fi but failed registration, discovery, or app permissions. Remove the duplicate entry and retry on the primary network. On this model, start with Canon PRINT and the official support instructions.
Should I factory reset before setup?
Use a network reset first. A full factory reset can erase useful settings and is rarely needed for a first setup failure.
Use the exact model guide.
These links point to the manufacturer support results for this model. Use the manual for panel symbols and the driver page for software or operating-system issues.