HP OfficeJet Pro 9015e
has a paper jam.
HP OfficeJet Pro 9015e has a paper jam? A paper-jam warning can remain after the torn sheet is gone. Remove paper in the feed direction and clear the sensor path without forcing the rollers. For this HP OfficeJet Pro 9015e, pay special attention to HP Smart pairing, the automatic document feeder, and 902-series cartridge alignment.
Try these in order.
Stop as soon as the printer behaves. Each step removes one likely cause without changing settings you may need later.
- 01
Turn it off and open every access door
Power down normally, unplug it, then check the rear access panel, cartridge or toner path, and output area with a flashlight. On the HP OfficeJet Pro 9015e, use HP Smart or the printer control panel for this check.
- 02
Pull paper in the feed direction
Grip both sides of the sheet and pull slowly toward the output path. Avoid yanking backward against the rollers.
- 03
Reload a small, flat stack
Use fresh paper, keep the stack below the fill line, and set the side guides so they touch the paper without bending it.
Usually one of these.
- HP Smart pairing, the automatic document feeder, and 902-series cartridge alignment is the model-specific checkpoint to verify first.
- A small piece of torn paper is blocking a sensor or roller.
- The paper stack is curled, damp, mixed-size, or over the tray limit.
Move to the deeper fix.
Reset the jam sensor
With the printer unplugged for 60 seconds, rotate only accessible rollers by hand and check that every guide and access door is fully closed.
Test with one sheet
Feed one sheet from the recommended tray. If one sheet works but a stack jams, the tray or paper condition is the likely cause. Use the official HP support page for the exact HP OfficeJet Pro 9015e package before changing firmware or resetting the device.
Before you reset everything.
Can I use tweezers to remove a paper jam?
Only for a loose, visible fragment that you can reach without touching the rollers or electronics. If paper is wrapped around a roller, follow the official service access instructions. On this model, start with HP Smart and the official support instructions.
Why does the jam warning stay on?
A small fragment, open cover, or unreset sensor can keep the warning active even after the main sheet is removed.
Use the exact model guide.
These links point to the manufacturer support results for this model. Use the manual for panel symbols and the driver page for software or operating-system issues.